Electric Exhaust Gas Recirculation (EGR) System
WARNING: This page does not describe the selected car, but rather 26 other vehicles, including the 2020 Lincoln Navigator, 2020 Lincoln Nautilus, 2020 Lincoln MKZ, 2020 Lincoln Corsair, and 2020 Lincoln Continental. However, it is still accessible from the selected car via links, so may be relevant.
The electric EGR system consists of an electric motor EGR valve integrated assembly, a manifold absolute pressure (MAP) sensor, PCM, and connecting wiring. For additional information on the EGR system components, refer to ENGINE CONTROL COMPONENTS . Operation of the system is as follows:
- The electric EGR system receives signals from the engine coolant temperature (ECT) or cylinder head temperature (CHT) sensor, throttle position (TP) sensor, mass airflow (MAF) sensor (if equipped), crankshaft position (CKP) sensor, and the MAP sensor to provide information on engine operating conditions to the PCM. The engine must be warm, stable, and running at a moderate load and RPM before the electric EGR system is activated. The PCM deactivates the EGR during idle, extended wide open throttle (WOT), or whenever a concern is detected in an EGR component or EGR required input.
- The PCM calculates the desired amount of EGR for a given set of engine operating conditions.
- The PCM in turn outputs signals to control the electric EGR motor to move (advance or retract) a calibrated number of discrete steps. The electric stepper motor directly actuates the EGR valve, independent of engine vacuum. The electric EGR valve is commanded from 0 to 52 discrete steps to get the EGR valve from a fully closed to a fully open position. The position of the EGR valve determines the EGR flow.
- A MAP sensor measures variations in manifold pressure as exhaust gas recirculation is introduced into the intake manifold. Variations in EGR being used correlate to the MAP signal (increasing EGR increases manifold pressure values).
Typical Electric EGR System