Normal Operation and Fault Conditions
WARNING: This page is about a different car, the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
When the driver presses the clutch pedal, the clutch pedal switch sends a signal to the PCM indicating the pedal has been pressed. The PCM sends a clutch pedal message to the GWM over the HS-CAN1. The GWM sends this message to the ABS module over the HS-CAN2. The ABS module monitors the clutch pedal message and vehicle speed. If the information indicates a concern with the clutch pedal, this DTC is set.
DTC DESCRIPTION
| DTC | Description | PPT AC ABS Module DTC Fault Trigger Conditions |
|---|---|---|
| C1A41:64 | Clutch Pedal Sensor: Signal Plausibility Failure | This DTC sets under a specific driving condition; if the vehicle is moving less than 3 km/h (2 mph) and after vehicle speed is greater than 80 km/h (49 mph) in the same ignition cycle, a clutch pedal signal change is expected to occur. If the clucth pedal signal change does not occur for 5 times, this DTC sets. |