Pinpoint Test G : The One-Touch Open/Close Is Inoperative

WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

G1 CHECK THE ROOF OPENING PANEL MOTORS FOR INITIALIZATION
- Carry out the roof opening panel motor initialization procedure for the sunroof and shield (sunshade). REFER to: Power Roof Opening Panel Initialization .
- Operate the system using one-touch.
Is the concern still present?

Yes GO to G2

No The system is operating normally at this time. The roof opening panel motor was not initialized.

G2 CHECK THE ROOF OPENING PANEL MOTOR/MODULES AND SWITCH FOR CORRECT OPERATION

Ignition OFF.

Disconnect All sunroof system and related in-line connectors.

Check for:
- corrosion - install new connector or terminals and clean module pins
- damaged or bent pins - install new terminals or pins
- pushed-out pins - install new pins as necessary

Connect all sunroof system and related in-line connectors and make sure they seat correctly.

Operate the system and verify the concern is still present.

Is the concern still present?

Yes

CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new roof opening panel motor and shield motor. REFER to: Roof Opening Panel Motor . TEST the system for normal operation. If the concern still exists, INSTALL a new roof opening panel control switch. REFER to: Roof Opening Panel Control Switch .

No	The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.