Rear Seat LH - SuperCab: Removal

WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal steps in this procedure may contain installation details.

Remove the RH seat. Refer to: Rear Seat RH - SuperCab .
Remove the outboard seatbelt retractor-to-seat bolt.
Torque: 30 lb.ft (40 Nm)

Courtesy of FORD MOTOR COMPANY
Remove the seat bolts.
1. Raise the LH seat cushion.
2. Remove the bolts.
  Torque: 26 lb.ft (35 Nm)
Courtesy of FORD MOTOR COMPANY
NOTE: The striker should be in its lowest position for the latch to engage.

Lower the LH seat backrest.
1. Pull the backrest release strap and release the latch from the striker.
2. Lower the backrest.
Courtesy of FORD MOTOR COMPANY
If equipped with a subwoofer, disconnect the electrical connector, remove the fasteners and the subwoofer.
Torque: 62 lb.in (7 Nm)

Courtesy of FORD MOTOR COMPANY
Remove the seat nuts.
Torque: 59 lb.ft (80 Nm)

Courtesy of FORD MOTOR COMPANY
Remove the seat.
1. Route center seatbelt through the cushion opening.
2. Remove the seat.

Courtesy of FORD MOTOR COMPANY