Rear Seat Cushion Cover - SuperCab: Removal

WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: LH shown, RH similar.

Remove the rear seat. Refer to: Rear Seat RH - SuperCab . Refer to: Rear Seat LH - SuperCab .
Release the lower cushion cover.
1. Release the cushion cover lower J-clip.
2. Unzip the cushion cover.
Courtesy of FORD MOTOR COMPANY
Position the rear seat latch pull strap through the cushion cover trim pocket.

Courtesy of FORD MOTOR COMPANY
NOTE: Use care when separating the seat cushion cover from the hook-and-loop strip or the hook-and-loop strip can be torn from the foam pad.

Remove the inboard and outboard cushion cover fasteners.
1. Release the hook-and-loop strip.
2. Remove the outboard cushion cover pin-type retainer.
3. Remove the inboard pivot bolt.
  Torque: 159 lb.in (18 Nm)
Courtesy of FORD MOTOR COMPANY
NOTE: Use care when separating the seat cushion cover from the hook-and-loop strip or the hook-and-loop strip can be torn from the foam pad.

NOTE: Use care when separating the seat cushion cover from the hook-and-arrow strip or the hook-and-arrow strip can be torn from the foam pad.

Remove the cushion cover from the foam pad.
1. Release the hook-and-arrows.
2. Release the hook-and-loop strips.

Courtesy of FORD MOTOR COMPANY