LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 451 (Parking Aid - Vehicles With: Parking Aid Camera) >> Diagnosis And Testing >> Parking Aid >> Pinpoint Test(s) >> Pinpoint Test P : The Manual Zoom Is Inoperative - Vehicles With 360 Degree View Camera >> Pinpoint Test P : The Manual Zoom Is Inoperative - Vehicles With 360 Degree View Camera

Pinpoint Test P : The Manual Zoom Is Inoperative - Vehicles With 360 Degree View Camera

WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

  1. P1 PERFORM A NETWORK TEST

    • Ignition ON.

    • Using a diagnostic scan tool, perform a network test.

    Do all modules pass the network test? 

    Yes  GO to  P2
    No  REFER to: Communications Network .
  2. P2 CHECK FOR RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE IPMB (IMAGE PROCESSING MODULE B) SELF-TEST

    • Using a diagnostic scan tool, perform the BCM self-test.

    Are any Diagnostic Trouble Codes (DTCs) present? 

    Yes  REFER to the DTC Chart: BCM .
    No  GO to  P3
  3. P3 CHECK FOR RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE APIM (SYNC MODULE) SELF-TEST

    • Using a diagnostic scan tool, perform the APIM self-test.

    Are any Diagnostic Trouble Codes present? 

    Yes  For DTC C1001:01, GO to Pinpoint Test A . For all other Diagnostic Trouble Codes (DTCs), REFER to: Information and Entertainment System .
    No  GO to  P4
  4. P4 CHECK FOR CORRECT REAR PARKING AID CAMERA OPERATION

    • Ignition OFF.

    • Disconnect and inspect the rear parking aid camera and related in-line connectors.

    • Repair:

      • corrosion (install new connector or terminals - clean module pins)
      • damaged or bent pins - install new terminals/pins
      • pushed-out pins - install new pins as necessary

    • Reconnect the rear parking aid camera and related in-line connectors. Make sure they seat and latch correctly.

    • Operate the system and determine if the concern is still present.

    Is the concern still present? 

    Yes  CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new rear parking aid camera. REFER to: Rear Parking Aid Camera .
    No  The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues.