Bodyside Molding: Removal
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
The following steps detail the various bodyside mouldings located on the cab and pickup bed. It is not all inclusive as trim levels may vary from vehicle to vehicle.
NOTE:
LH side views shown, RH side similar.
Cab Upper Molding
- Using a non-marring trim tool, detach the 7 push pin retainers and remove the molding.
Cab Lower Molding
- Remove the push pin from the lower cab corner molding.
- Using a non-marring trim tool, detach the 7 push pin retainers and remove the lower cab corner molding.
Pickup Bed Lower Molding
- Remove the 6 push pin retainers.
- Using a non-marring trim tool, detach the retainers from pick up bed and remove the molding.
Pickup Bed Upper Rail Molding
- Using a non-marring trim tool, carefully detach the retainers along the length of the molding and remove the molding.