LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 429 (Fuel Charging And Controls - Turbocharger - 3.0L Power Stroke Diesel) >> Diagnosis And Testing >> Turbocharger >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This article provides mechanical diagnosis of the turbocharger assembly. If there is a MIL illuminated, or a DTC is present, these should be diagnosed prior to performing turbocharger mechanical diagnosis.
  1. For a PCM DTC, REFER to: Electronic Engine Controls . For driveability symptoms without a DTC, Refer to Engine Controls - Symptom Charts (Diesel)
  2. Verify the customer concern.
  3. Visually inspect for obvious signs of mechanical or electrical damage.

    Visual Inspection Chart 

    Mechanical Electrical
    Air cleaner element
    Air cleaner intake pipe
    Air cleaner outlet pipe
    Charge air cooler
    Charge air cooler intake pipe
    Charge air cooler outlet pipe
    Coolant leak(s)
    Oil leak(s)
    Turbocharger coolant return tube
    Turbocharger coolant supply tube
    Turbocharger housing
    Turbocharger intake tube
    Turbocharger oil return tube
    Turbocharger oil supply tube
    VNT actuator
    Electrical connector(s)
    Powertrain control module
    Wiring harness(es)
  4. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
  5. If the concern is not visually evident, verify the symptom and refer to the Diagnostic Tab in the Ford diagnostic equipment.