Fuel Rail Supply Tube RH: Installation
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
-
NOTE: Make sure that a new fuel rail supply tube is installed.
Install a new fuel rail supply tube then, tighten the fuel supply tube fittings finger tight at this stage.
- Install the fuel rail supply tube bracket, then install and tighten bolt.
Torque: 89 lb.in (10 Nm)
- Install a new fuel rail supply tube, then install the bracket bolt. Tighten the fuel supply tube fittings and the bracket bolt finger tight at this stage. Tighten in the following 6 stages.
Torque: Stage 1: Tighten the fuel injection pump fitting to: : 89 lb.in (10 Nm) | Stage 2: Tighten the fuel rail fitting to: : 89 lb.in (10 Nm) | Stage 3: Tighten the fuel injection pump fitting to: : 142 lb.in (16 Nm) | Stage 4: Tighten the fuel rail fitting to: : 142 lb.in (16 Nm) | Stage 5: Tighten the fuel injection pump fitting an additional: : 50 deg. | Stage 6: Tighten the fuel rail fitting an additional: : 50 deg.
- Install the insulator.
- Attach the wire harness and the coolant hose retainers.
- Attach the wire harness retainers, then install and tighten the wire harness bolt.
Torque: 89 lb.in (10 Nm)
-
- Install the vacuum tube assembly, then attach the vacuum reservoir retainers.
- Attach the valve to the bracket.
- Connect the electrical connector, then connect the quick release coupling. Refer to Quick Release Coupling
- Attach the vacuum tube retainers, then connect the vacuum hose at the EGR.
- Attach the wiring harness bracket to the rear engine lifting eye and to the transmission case.
- Install the right front fender splash shield. Refer to: Fender Splash Shield .
- Install the secondary fuel filter, then install and tighten the bolt.
Torque: 89 lb.in (10 Nm)
-
- If equipped, attach the vacuum tube retainers.
- If equipped, connect the quick release coupling. Refer to Quick Release Coupling .
- Connect the fuel tube assembly quick release coupling. Refer to QUICK RELEASE COUPLING
-
- Install fuel supply tube assembly, then install and tighten the bolt.
Torque: 17 lb.ft (23 Nm)
- Connect the fuel supply tube assembly quick release couplings. Refer to QUICK RELEASE COUPLING :
- Install fuel supply tube assembly, then install and tighten the bolt.
- Connect the fuel supply tube assembly electrical connector, then attach the wire retainer.
- Connect the quick release couplings, then attach the fuel tube retainers. Refer to QUICK RELEASE COUPLING
- Connect the battery negative cable. Refer to: Battery Disconnect and Connect .
- Bleed the fuel system. Refer to: Fuel System Bleeding .
- Install the engine appearance cover bracket, then install and tighten the retainers.
Torque: 44 lb.in (5 Nm)
- Install the engine appearance cover.