Fuel Rail RH: Removal
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Do not work on the fuel system until the pressure has been released and the engine has cooled. Fuel in the high-pressure fuel system is hot and under very high pressure. High-pressure fuel may cause cuts and contact with hot fuel may cause burns. Failure to follow these instructions may result in serious personal injury.
NOTE:
Fuel injection equipment is manufactured to very precise tolerances and fine clearances. To prevent fuel system damage, it is essential that absolute cleanliness is observed when working with these components.
- Remove and discard the fuel rail supply tube RH. Refer to: Fuel Rail Supply Tube RH .
- Remove and discard the fuel injector supply tubes RH. Refer to: Fuel Injector Supply Tube RH .
- Remove and discard the fuel rail balance tube. Refer to: Fuel Rail Balance Tube .
- Disconnect the electrical connector, then detach the wire retainer.
- Remove the bolts, then remove the right fuel rail.