Oil Pump: Installation
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Prime the oil pump. Add 2 tablespoons of clean engine oil to the oil pump and rotate the oil pump by hand.
-
NOTE: Oil pump must be held against the cylinder block until all bolts are tightened.
- Rotate the inner rotor of the oil pump assembly to align the flats on the crankshaft and slip the oil pump over the crankshaft until seated against the block.
- Rotate the oil pump until the bolt holes are aligned to the block and install the fasteners hand tight.
Torque:| Stage 1: A: 89 lb.in (10 Nm) | Stage 2: B: 18 lb.ft (25 Nm) | Stage 3: C: 89 lb.in (10 Nm) | Stage 4: D: 177 lb.in (20 Nm) | Stage 5: A: 45° | Stage 6: B: 75° | Stage 7: C: 45° | Stage 8: D: 60°
- Install the oil pan. Refer to: Oil Pan .
- Install the crankshaft sprocket.
- Install the timing chains. Refer to: Timing Chain .