Crankshaft Rear Seal: Installation
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Lubricate the seal bore and the seal lips with clean engine oil.
-
- Position the special tool onto the end of the crankshaft. Use Special Service Tool: 303-1250 Seal Installer, Rear Main.
- Slide the new crankshaft rear seal onto the tool.
- Using the special tools, install the crankshaft rear seal. Use Special Service Tool: 205-153 (T80T-4000-W) Handle., 303-1250 Seal Installer, Rear Main.
- Install the crankshaft sensor ring and the engine-to-transmission spacer plate.
- Install the flexplate. Refer to: Flexplate .