Selector Shaft Seal: Removal
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
- If equipped, release the retainers and remove the splash shield.
- If equipped, remove the bolt and the selector lever cable splash shield.
-
NOTE: To prevent selector lever cable damage, do not apply force to the selector lever cable between the manual control lever and the selector lever cable bracket.
Disconnect the selector lever cable from the manual control lever.
- Remove the nut and the manual control lever.
- Remove and discard the selector shaft seal (7F337).