Principles of Operation

Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. For information about these, REFER to: Diagnostic Methods .

The turbocharger is an exhaust-driven centrifugal air compressor. Its purpose is to increase power output by supplying compressed air to the engine.

Expanding exhaust gases drive the turbine shaft assembly to speeds up to 200, 000 rpm. Filtered air entering the compressor side of the turbocharger is compressed and delivered through a charge air cooler. The very hot compressed air is cooled by the charge air cooler, then continues on to fill the intake manifold at a higher pressure than atmospheric pressure. Because considerably more air is forced into the intake manifold, the results are increased power, fuel efficiency and the ability to maintain power at higher altitudes.

The turbocharger is governed by a electric wastegate actuator. The electric wastegate actuator redirects some of the exhaust gas past the turbine and therefore acts as a governor. The electric wastegate actuator is controlled by the powertrain control module.

The intake air system is fitted with a turbocharger bypass valve. This vents the intake air system when the throttle is closed and recirculates the air back into the intake air system. It also releases pressure on the turbocharger which will reduce turbo lag and improve acceleration and increase engine performance.

The internal components are oil, coolant and air cooled. Engine oil and coolant are circulated through the center housing which acts as a heat barrier between the "hot" turbine and the "cold" compressor. Bearings are sleeve type and lubricated by engine oil. Oil is circulated to the turbocharger center housing and returned to the engine oil sump through an oil drain in the center housing.