Ignition Coil-On-Plug: Installation

WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Both sides

Inspect the ignition coil-on-plugs. Replace any damaged ignition coil-on-plugs. Replace any of the ignition coil-on-plug boots with cracks, rips or tears.

Courtesy of FORD MOTOR COMPANY
1. Install the ignition coil-on-plugs.
2. Install and tighten the ignition coil-on-plug retainers.
  Torque
  
  :Stage 1: 62 lb.in (7 Nm)Stage 2: 50 deg.
Courtesy of FORD MOTOR COMPANY
Connect the ignition coil-on-plug electrical connectors.

Courtesy of FORD MOTOR COMPANY

Left side
Connect the crankcase ventilation tube, then connect the electrical connector.

Courtesy of FORD MOTOR COMPANY

Both sides
Install the engine appearance cover into the rear retainers, then install and tighten the engine appearance cover retainers.
Torque

: 97 lb.in (11 Nm)

Courtesy of FORD MOTOR COMPANY