Oil Cooler - Raptor: Removal
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
- Remove the engine appearance cover retainers. Release the engine appearance cover from the rear retainers and then remove the engine appearance cover.
- Remove the air cleaner outlet pipe LH. Refer to: Air Cleaner Outlet Pipe LH .
- Remove the bolts and the skid plate.
- Remove and discard the engine oil filter. Use the General Equipment: Oil Drain Equipment
- Disconnect the block heater cord.
-
- Using hose locking pliers, clamp the oil cooler coolant hoses. Use the General Equipment: Locking Pliers
- Using the hose clamp remover, remove the coolant hoses. Use the General Equipment: Hose Clamp Remover/Installer
-
NOTE: If metal or foreign material is present in the oil cooler, mechanical concerns exist. To diagnose the mechanical concerns refer to Engine .
Remove the retainer and the oil cooler.