LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 392 (Automatic Transmission - 6-Speed Automatic Transmission - 6R80) >> Removal And Installation >> Transmission Fluid Auxiliary Pump >> Removal

Transmission Fluid Auxiliary Pump: Removal

WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
  2. If equipped, release the retainers and remove the splash shield.
    GFD463555Courtesy of FORD MOTOR COMPANY
  3. Disconnect the transmission fluid auxiliary pump electrical connector.
    GFD463556Courtesy of FORD MOTOR COMPANY
  4. NOTE: Do not use power tools to remove the transmission fluid auxiliary pump bolts or damage can occur.

    Remove the bolts and the transmission fluid auxiliary pump.

    1. Apply heat to the bolts to soften the Loctite®.
    2. Remove and discard the bolts.

    multimedia:A supplement to the article is available.
    GFD463557Courtesy of FORD MOTOR COMPANY
  5. Remove the transmission fluid auxiliary pump gasket.
    GFD463558Courtesy of FORD MOTOR COMPANY
  6. Clean and inspect the transmission fluid auxiliary pump mounting surface.

    1. NOTE: Be sure the transmission fluid auxiliary pump bolt holes are free from loose Loctite®.

GFD463559Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals