Transmission Fluid Cooler Supply Tube - 3.3L Duratec-V6: Removal
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in N, position it on a hoist. Refer to: Jacking and Lifting - Overview .
- Remove the transmission fluid cooler supply tube secondary latch.
-
NOTE: Be prepared to collect escaping fluid.
Using the special tool, disconnect the transmission fluid cooler supply tube from the cooler bypass valve. Use Special Service Tool: 307-569 Disconnect Tool TOC Line (1/2).
- Remove the transmission fluid cooler supply tube bracket bolt and disconnect the wiring harness standoff.
- Remove the bolts and position the degas bottle aside.
- Remove the pushpins, the bolt and the air cleaner intake pipe.
- Remove the transmission fluid cooler supply tube bracket bolt.
- Remove the active grille shutter. Refer to: Active Grille Shutter .
- Remove the pushpins and the LH radiator air deflector.
-
NOTE: Be prepared to collect escaping fluid.
Release the clamp and disconnect the transmission fluid cooler supply tube.
- Remove the transmission fluid cooler supply tube.