Turbocharger Oil Supply Tube LH: Installation
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Install the new turbocharger oil supply tube O-ring seals and the new turbocharger oil supply tube oil filter. Lubricate the new turbocharger oil supply tube O-ring seals with clean engine oil. Refer to: Specifications
.
-
NOTE: Carefully use a nylon brush to remove the old O-ring residue and use brake cleaner to rinse the O-ring residue out of the turbocharger tube to turbocharger O-ring bore and the turbocharger tube to engine O-ring bore. Inspect the area for deep scratches and gouges. Do-not use a metal brush; damage to sealing area will result in leaks.
Install the turbocharger oil supply tube, then loosely install the oil supply tube bolt.
Material: Motorcraft® Metal Brake Parts Cleaner / PM-4-A, PM-4-B
-
NOTE: Carefully use a nylon brush to remove the old O-ring residue and use brake cleaner to rinse the O-ring residue out of the turbocharger tube to turbocharger O-ring bore and the turbocharger tube to engine O-ring bore. Inspect the area for deep scratches and gouges. Do-not use a metal brush; damage to sealing area will result in leaks.
Connect the turbocharger oil supply tube to the turbocharger, then install and tighten the turbocharger oil supply tube bolt.
Material: Motorcraft® Metal Brake Parts Cleaner / PM-4-A, PM-4-B
Torque: 89 lb.in (10 Nm)
- Tighten the turbocharger oil supply tube bolt.
Torque: 89 lb.in (10 Nm)
- Install and tighten the turbocharger mounting stud.
Torque: 106 lb.in (12 Nm)
- Install the tighten the upper left turbocharger nut.
Torque: Stage 1: Tighten the nut to : 44 lb.ft (60 Nm) | Stage 2: Re-tighten the nut to : 44 lb.ft (60 Nm)
- Install the new EGR tube gaskets.
- Install the EGR tube, then install and tighten the EGR tube retainers.
Torque: Nuts : 89 lb.in (10 Nm) Bolts : 89 lb.in (10 Nm)
- Install the air tube bracket, then install and the air tube bracket retainers.
Torque: Nut : 53 lb.in (6 Nm) Bolt : 53 lb.in (6 Nm)
- Install the left charge air cooler intake pipe. Refer to: Charge Air Cooler (CAC) Intake Pipe .
- Install the air cleaner outlet pipe LH. Refer to: Air Cleaner Outlet Pipe LH .
- Install the engine appearance cover, then install and tighten the engine appearance cover retainers.
Torque: 42 lb.in (4.8 Nm)
- Check and top off the engine oil level as needed. Refer to: Specifications .
- Start and check for leaks.