Turbocharger Coolant Supply Tube LH: Installation

WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

If the turbocharger coolant supply tube was removed from the turbocharger, then install a new turbocharger end coolant supply tube O-ring seal. Lubricate the new O-ring seal with clean engine coolant. Refer to: Specifications .

Courtesy of FORD MOTOR COMPANY
Install a new turbocharger coolant supply tube O-ring seal. Lubricate the new O-ring seal with clean engine coolant. Refer to: Specifications .

Courtesy of FORD MOTOR COMPANY
NOTE: Carefully use a nylon brush to remove the old O-ring residue and use brake cleaner to rinse the O-ring residue out of the turbocharger tube to turbocharger O-ring bore. Inspect the area for deep scratches and gouges. DO NOT USE A METAL BRUSH; DAMAGE TO SEALING AREA WILL RESULT IN LEAKS.

NOTE: Carefully use a nylon brush to remove the old O-ring residue and use brake cleaner to rinse the O-ring residue out of the turbocharger tube to engine O-ring bore. Inspect the area for deep scratches and gouges. DO NOT USE A METAL BRUSH; DAMAGE TO SEALING AREA WILL RESULT IN LEAKS.

Install the turbocharger coolant supply tube, then install and tighten the bolt.

Material: Motorcraft® Metal Brake Parts Cleaner / PM-4-A, PM-4-B

Torque: 89 lb.in (10 Nm)

Courtesy of FORD MOTOR COMPANY
Install and tighten the turbocharger coolant supply tube bolt.
Torque: 18 lb.ft (24 Nm)

Courtesy of FORD MOTOR COMPANY
Install the NEW EGR tube gaskets.

Courtesy of FORD MOTOR COMPANY
Install the EGR tube, then install and tighten the EGR tube retainers.
Torque: Nuts : 89 lb.in (10 Nm) | Bolts : 89 lb.in (10 Nm)

Courtesy of FORD MOTOR COMPANY
Install the air tube bracket, then install and the air tube bracket retainers.
Torque: Nut : 53 lb.in (6 Nm) | Bolt : 53 lb.in (6 Nm)

Courtesy of FORD MOTOR COMPANY
Install the left charge air cooler intake pipe. Refer to: Charge Air Cooler (CAC) Intake Pipe .
Install the air cleaner outlet pipe LH. Refer to: Air Cleaner Outlet Pipe LH .
If equipped, install the skid plate or splash shield, then install and tighten the bolts.
Torque: 30 lb.ft (40 Nm)

Courtesy of FORD MOTOR COMPANY
If equipped, install the transmission housing cover, then install and tighten the retainers.
Torque: 71 lb.in (8 Nm)

Courtesy of FORD MOTOR COMPANY
Fill the cooling system. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding .
Start and check for leaks.