Selector Lever Cable Adjustment - Raptor

WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

For information on Ford Color Coded Illustrations refer to OEM Color Coding .

Adjustment

With the vehicle in N, position it on a hoist. Refer to: Jacking and Lifting - Overview .
Position the selector lever in D.

Courtesy of FORD MOTOR COMPANY
Remove the bolts and the shield.

Courtesy of FORD MOTOR COMPANY
NOTE: To prevent selector lever cable damage, do not apply force to the selector lever cable between the manual control lever and the selector lever cable bracket.

Rotate the cable adjuster lock upward and disconnect the selector lever cable from the manual control lever.

Courtesy of FORD MOTOR COMPANY
Position the manual lever in D.
1. Rotate the manual lever clockwise until it stops.
2. Rotate the manual lever counterclockwise 3 detents.
Courtesy of FORD MOTOR COMPANY
Unlock the cable adjuster lock.

Courtesy of FORD MOTOR COMPANY
Connect the selector lever cable to the manual control lever.

Courtesy of FORD MOTOR COMPANY
Lock the cable adjuster lock.

Courtesy of FORD MOTOR COMPANY
Verify the vehicle starts in P and N only and that the reverse lamps illuminate in R.
Install the bolts and the shield.
Torque: 52 lb.ft (71 Nm)

Courtesy of FORD MOTOR COMPANY