Pinpoint Test G : U3008:13: Notes
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
A trailer must be connected
to the vehicle for this DTC to set.
Refer to Trailer/Camper Adapter for schematic and connector information
Normal Operations and Fault Conditions
The TBM receives battery and ignition voltage from BJB fuses 49 (30A). The TBM has a single ground circuit.
An open circuit in the wiring or a condition resulting in an open in the ground circuit, such as an internal failure of the TBM or a connector concern, results in the TBM setting this DTC. When this DTC sets, the TBM disables trailer braking and sends a TBC FAULT message to the message center. If a trailer is not connected to the vehicle when this DTC sets, the TBM sends a TRAILER BRAKE MODULE FAULT message to the message center.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U3008:13 | Ground ECU Circuit Open | This DTC sets in continuous memory and on-demand when the TBM detects a rise in battery voltage greater than 19 volts during a braking event and while not braking, the battery voltage rises greater than 0.75 volt after sending the PWM trailer connectivity test pulse. |
Possible Sources
- Wiring, terminals or connectors
- TBM