LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 362 (Cruise Control - Vehicles With: Adaptive Cruise Control) >> Diagnosis And Testing >> Cruise Control >> Pinpoint Tests >> Pinpoint Test J : U0140:00 >> Pinpoint Test J : U0140:00

Pinpoint Test J : U0140:00

WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

  1. J1 VERIFY THE CUSTOMER CONCERN

    • Ignition ON.

    • Verify there is an observable symptom present.

    Is an observable symptom present? 

    Yes  GO to  J2
    No  The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

  2. J2 CHECK THE COMMUNICATION NETWORK

    • Using a diagnostic scan tool, perform the network test.

    Does the BCM pass the network test? 

    Yes  GO to  J3
    No  REFER to Communications Network .

  3. J3 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)

    • Using a diagnostic scan tool, retrieve the GWM Continuous Memory Diagnostic Trouble Codes (CMDTCs).

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to Communications Network
    No  GO to  J4

  4. J4 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE CCM (CRUISE CONTROL MODULE) AND BCM (BODY CONTROL MODULE) SELF-TEST

    • Using a diagnostic scan tool, perform the CCM and BCM self-test.

    Is DTC U3003:16 or U3003:17 recorded? 

    Yes  If CCM, DTC U3003:16 is recorded, GO to Pinpoint Test Q  If CCM, DTC U3003:17 is recorded, GO to Pinpoint Test R  If the Diagnostic Trouble Codes (DTCs) are recorded in the BCM, REFER to Body Control Module (BCM)
    No  GO to  J5

  5. J5 RECHECK THE CCM (CRUISE CONTROL MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)

    NOTE: If new modules were installed prior to the DTC being set, the module configuration can be incorrectly set during the PMI or the PMI may not have been performed.

    • Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs). Repeat the CCM self-test.

    Is DTC U0140:00 still present? 

    Yes  GO to  J6
    No  The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

  6. J6 CHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) U0140:00

    • Clear all Diagnostic Trouble Codes (DTCs).

    • Ignition OFF.

    • Ignition ON.

    • Wait 10 seconds.

    • Using a diagnostic scan tool, retrieve the Continuous Memory Diagnostic Trouble Codes (CMDTCs) from all modules.

    Is DTC U0140:00 set in other modules? 

    Yes  CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, Refer to BCM Guided Routine .
    No  CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new CCM. REFER to Cruise Control Module (CCM) :
scientia non olet · About LEMON Manuals