LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 359 (Front Seats (2 Of 2)) >> Diagnosis And Testing >> Front Seats >> Pinpoint Test(s) >> Pinpoint Test P : The Right Heated Seat Is Inoperative -- With Heated/Ventilated Seats >> Notes

Pinpoint Test P : The Right Heated Seat Is Inoperative -- With Heated/Ventilated Seats: Notes

WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Refer to Climate Controlled Seats for schematic and connector information.

Normal Operation and Fault Conditions 

REFER to: Front Seats - System Operation and Component Description .

DTC Fault Trigger Conditions 

DTC Description Fault Trigger Conditions
B1151:4B Passenger Seat Cushion: Over Temperature Sets when the SCME senses the right front cushion temperature has exceeded 110 deg.C (230 deg.F) for more than 4 seconds. When this DTC sets, the SCME disables the circuit until the ignition is cycled.
B1155:01 Passenger Seat: General Electrical Failure Sets when the SCME senses the right front heater element current draw has exceeded a specified threshold. When this DTC sets, the SCME disables the circuit until the ignition is cycled.
B1155:11 Passenger Seat: Circuit Short To Ground Sets when the SCME senses the right front heater element current draw has exceeded a specified threshold. When this DTC sets, the SCME disables the circuit until the ignition is cycled.
B1155:12 Passenger Seat: Circuit Short To Battery Sets when the SCME senses the right front heater circuit voltage is above a specified threshold when the driver is active. When this DTC sets, the SCME disables the circuit until the ignition is cycled.
B1155:13 Passenger Seat: Circuit Open Sets when the SCME senses the right front heater element current draw is less than a specified threshold. When this DTC sets, the SCME disables the circuit until the ignition is cycled.
B1155:1A Passenger Seat: Circuit Resistance Below Threshold Sets when the SCME senses the right front heater element current draw is more than a specified threshold. When this DTC sets, the SCME disables the circuit until the ignition is cycled.
B120A:01 Passenger Seat Cushion Temperature Sensor: General Electrical Failure Sets when the SCME senses the right front heater sensor voltage is out-of-range low or high. When this DTC sets, the SCME disables the circuit until the ignition is cycled.
B120A:11 Passenger Seat Cushion Temperature Sensor: Circuit Short To Ground Sets when the SCME senses the right front heater sensor voltage is out-of-range low. When this DTC sets, the SCME disables the circuit until the ignition is cycled.
B120A:15 Passenger Seat Cushion Temperature Sensor: Circuit Short To Battery or Open Sets when the SCME senses the right front heater sensor voltage is out-of-range high. When this DTC sets, the SCME disables the circuit until the ignition is cycled.

Possible Causes