Driver Power Seat - With Memory

WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

The driver 10-way seat (with memory) is controlled by the DSM. The DSM is located on the driver seat track. The DSM hard stop/soft stops must be set/reset any time a new DSM, driver seat track or driver seat backrest is installed.

The memory system allows automatic positioning of the driver seat to 1 of 3 programmable positions. For information on programming memory positions or recalling a stored memory position, refer to the Owner's Literature.

The driver memory seat is equipped with the following motors:

Front height motor (serviced with seat track assembly)
Rear height motor (serviced with seat track assembly)
Horizontal motor (serviced separately from the seat track assembly)
Recliner motor (serviced with seat backrest assembly)
Lumbar motor (serviced with power lumbar assembly)

The memory seat also has an easy entry/exit feature. The easy entry/exit feature is a function of the DSM that moves the driver seat back approximately 50.8 mm (2 in) (unless seat is already positioned at or near the end of travel) when the ignition is turned off. The DSM cancels this operation if a valid input command is received from the driver seat control switch, memory set switch, exterior mirror control switch or if the function has been disabled. The easy entry/exit feature can be enabled/disabled on the message center. For information on programming vehicle settings in the message center, refer to the Owner's Literature.