Rear Brake Outer Flexible Hose - Raptor: Removal

WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure that all openings are sealed.

NOTE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

NOTE: Removal steps in this procedure may contain installation details.

NOTE: RH side shown, LH side similar.

Remove the wheel and tire. Refer to: Wheel and Tire .
Detach the EPB wiring harness retainer.

Courtesy of FORD MOTOR COMPANY
Detach the wheel speed sensor wiring retainer.

Courtesy of FORD MOTOR COMPANY
Remove the bolt and disconnect the brake hose. Discard the washers.
Torque: 26 lb.ft (35 Nm)

Courtesy of FORD MOTOR COMPANY
Detach the brake flexible hose/tube assembly retainer.

Courtesy of FORD MOTOR COMPANY
Disconnect the brake tube fitting and remove the rear RH outer brake flexible hose/tube assembly.
Torque: 26 lb.ft (35 Nm)

Courtesy of FORD MOTOR COMPANY