Pinpoint Test N : Height Sensor Plausibility Failure Concern
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Normal Operation and Fault Conditions
REFER to: Vehicle Dynamic Suspension - System Operation and Component Description .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition VDM C1A03:64 Left Front Height Sensor: Signal Plausibility Failure Sets as a continuous memory and on-demand DTC due to incomplete or improper VDM programming. VDM C1A04:64 Right Front Height Sensor: Signal Plausibility Failure Sets as a continuous memory and on-demand DTC due to incomplete or improper VDM programming. Possible Sources
- VDM configuration
- VDM
- N1 CHECK THE VEHICLE SERVICE HISTORY
- Check the vehicle service history for recent service actions related to the VDM.
Are any recent service actions related to the VDM found?
Yes INSTALL As-Built data for the VDM following the diagnostic scan tool instructions. REFER to: Module Programming . No The system is operating correctly at this time. The concern may have been caused by an intermittent condition. - N2 RECHECK THE VDM (VEHICLE DYNAMICS CONTROL MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)
- Ignition ON.
- Using a diagnostic scan tool, clear the VDM Diagnostic Trouble Codes (DTCs).
- Carry out the VDM self-test.
Is DTC C1A03:64 or C1A04:64 still present?
Yes INSTALL a new VDM. REFER to: Vehicle Dynamics Control Module (VDM) No The system is operating correctly at this time. The concern may have been caused by an intermittent condition.