LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Information Center - Instrumentation, Message Center And Warning Chimes) >> Description And Operation >> Instrument Panel Cluster (IPC) - System Operation and Component Description >> System Operation >> Network Message Chart - Gauges

Network Message Chart - Gauges

WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

Module Network Input Messages - IPC 

Broadcast Message Originating Module Message Purpose
Diesel exhaust fluid level indicator PCM Input used to control the virtual diesel exhaust fluid level gauge.
Engine coolant temperature data PCM Input used to control the temperature gauge and the virtual temperature gauge.
Engine off status BCM Input provides the length of time the engine is off used to calculate the rate of change for the transmission temperature gauge.
Engine overheat indication request PCM Input used to send the temperature gauge to full hot.
Engine rpm data PCM Input used to control the tachometer indication.
Input used to calculate the rate of change for the transmission temperature gauge.
Ignition status BCM Ignition RUN, START and accessory states required for the IPC operating modes and fault reporting.
Oil pressure warning indicator request PCM Input used to control the oil pressure gauge and the virtual oil pressure gauge.
Transmission fluid temperature data PCM (gas engine) or TCM (diesel engine) Input used to control the transmission temperature gauge and the virtual transmission temperature gauge.
Turbo boost data PCM Input used to control the virtual turbo boost gauge.
Vehicle speed PCM Vehicle speed data used for the speedometer indication.
scientia non olet · About LEMON Manuals