Muffler and Tailpipe: Removal

WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Muffler and tailpipe assemblies will vary in configuration with different wheelbases and powertrains. Typical application shown.

NOTE: Removal steps in this procedure may contain installation details.

With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
Loosen the clamp.
Torque: 35 lb.ft (48 Nm)

Courtesy of FORD MOTOR COMPANY
Loosen the muffler inlet pipe flange bolts.
Torque: 30 lb.ft (40 Nm)

Courtesy of FORD MOTOR COMPANY
Release the locator tab out of the muffler inlet pipe.

Courtesy of FORD MOTOR COMPANY
Slide the muffler and tailpipe rearward out of the isolators and remove the muffler and tailpipe.

Courtesy of FORD MOTOR COMPANY