LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Automatic Transmission - 6-Speed Automatic Transmission - 6R140) >> General Procedures >> Adaptive Learning Drive Cycle

Adaptive Learning Drive Cycle

WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

For information on Ford Color Coded Illustrations refer to OEM COLOR CODING .

Configuration 

NOTE: Always drive the vehicle in a safe manner according to driving conditions and obey all traffic laws.
  1. Connect the scan tool to the vehicle.
  2. NOTE: Do not clear the PCM Keep Alive Memory (KAM).

    Using the scan tool, clear the Transmission Control Module (TCM) KAM and the adaptive table before conducting a solenoid body strategy drive cycle.

  3. Using the scan tool verify the transmission fluid is at normal operating temperature, between 91 °-102°C (196 °-216°F). If the transmission fluid is not at operating temperature, drive the vehicle until the normal operating temperature is achieved.
  4. NOTE: The transmission fluid must be at operating temperature before continuing with this step.
    NOTE: Drive the vehicle on a level road surface to perform the solenoid body strategy.

    1. Apply the park brake.
    2. With the engine running and the brakes applied, move the selector lever in the following sequence pausing between each position for four seconds. Begin in Neutral, N-R-N-D-R-D-N. Repeat this sequence two additional times.
    3. Release the park brake and accelerate at moderate throttle so each shift occurs around 2, 000 rpm for gasoline engines and 1, 500 rpm for diesel engines up to 105 k/mh (65 mph). Brake moderately to a stop. Repeat this sequence two additional times.
    4. Accelerate at moderate throttle so each shift occurs around 3, 000 rpm for gasoline engines and 2, 250 rpm for diesel engines up to 105 k/mh (65 mph). Brake moderately to a stop. Repeat this pattern two additional times.
    5. Stop the vehicle and apply the park brake.
    6. With the engine running and the brakes applied, move the selector lever in the following sequence pausing between each position for four seconds. Begin in NEUTRAL, N-R-N-D-R-D-N. Repeat this sequence two additional times.