Nitrogen Oxides (NOx) Sensor Module 12: Removal

WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Some vehicles built on or before 11/01/2016, the nitrogen oxides (NOx) module 12 is installed using adhesive tape and a locator pin during vehicle assembly. If removal of any of these components is required for service, the adhesive tape is not required for reinstallation. To reinstall, utilize pin fastener W717460-S300 to secure the module. Three pins are required for NOx module 12.

NOTE: Removal steps in this procedure may contain installation details.

The NOX12 is serviced as an assembly with the NOX (oxides of nitrogen) sensor. For additional information, Refer to: Nitrogen Oxides (NOx) Sensor 12 .