LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 261 (Fuel Charging And Controls - 6.7L Power Stroke Diesel) >> Removal And Installation >> Fuel Pump Driver Module (FPDM) >> Removal

Fuel Pump Driver Module (FPDM): Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, 2019 Ford F-250 Super Duty, and 2018 Ford F-550 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles 

  1. With the vehicle in NEUTRAL, position it on a hoist. Refer to: JACKING AND LIFTING - OVERVIEW (2018)Jacking and Lifting - Overview (2019) .

    Pickup 

    NOTE: The fuel pump driver module (FPDM) is attached to the top of the frame rear crossmember.
  2. Disconnect the fuel pump driver module (FPDM) electrical connector.
    GFD407722Courtesy of FORD MOTOR COMPANY
  3. Remove the fuel pump driver module (FPDM) retainers and then remove the fuel pump driver module (FPDM).
    GFD407723Courtesy of FORD MOTOR COMPANY

    Chassis Cab 

    NOTE: The fuel pump driver module (FPDM) is attached to the front of the frame rear crossmember.
  4. Disconnect the fuel pump driver module (FPDM) electrical connector.
    GFD407724Courtesy of FORD MOTOR COMPANY
  5. Remove the fuel pump driver module (FPDM) retainers and then remove the fuel pump driver module (FPDM).
GFD407725Courtesy of FORD MOTOR COMPANY