LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 195 (Automatic Transmission, Transfer Case And Power Transfer Unit - 6-Speed Automatic Transmission - 6R140 (2 Of 2)) >> Removal And Installation >> Extension Housing Seal >> Removal

Extension Housing Seal: Removal

WARNING: This page is about a different car, the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
    1. Index mark the rear driveshaft and output shaft flange.
    2. Remove and discard the driveshaft to output shaft flange bolts and the bearing straps (4A254).
    GFD408742Courtesy of FORD MOTOR COMPANY
  3. Remove and discard the center bearing mounting bolts from the center bearing bracket. Position aside and support the driveshaft.
    GFD408743Courtesy of FORD MOTOR COMPANY
  4. Remove the bolt, washer and the output shaft flange.
    GFD408744Courtesy of FORD MOTOR COMPANY
  5. Remove the transmission support insulator. Refer to: Transmission Support Insulator .
  6. Remove the extension housing bolts and the extension housing.
    GFD408745Courtesy of FORD MOTOR COMPANY
  7. Remove and discard the O-ring seal (7B031) from the extension housing.
    GFD408746Courtesy of FORD MOTOR COMPANY
  8. Remove and discard the rear bushing fluid feed seal (7H366).
GFD408747Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals