BCM DTC Chart
WARNING: This page is about a different car, the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
| DTC | Description | Action |
|---|---|---|
| B108A:01 | Start Button: General Electrical Failure | GO to Pinpoint Test F |
| B108A:24 | Start Button: Signal Stuck High | GO to Pinpoint Test F |
| B1142:29 | Ignition Status 1: Signal Invalid | For vehicles equipped with a conventional ignition switch, GO to Pinpoint Test C For vehicles equipped with a push button ignition switch, GO to Pinpoint Test F |
| B1240:11 | Start Button Mode Indicator: Circuit Short to Ground | GO to Pinpoint Test G |
| B1240:15 | Start Button Mode Indicator: Circuit Short to Battery or Open | If the ignition mode indicator is inoperative, GO to Pinpoint Test G If the ignition mode indicator is always on, GO to Pinpoint Test H |
| B130F:12 | Run Accessory Control: Circuit Short to Battery | REFER to: Wipers and Washers . |
| B130F:14 | Run Accessory Control: Circuit Short to Ground or Open | REFER to: Wipers and Washers . |
| B1310:12 | Run/Start Control: Circuit Short to Battery | For vehicles equipped with a conventional ignition switch, GO to Pinpoint Test C For vehicles equipped with a push button ignition switch, GO to Pinpoint Test F |
| B1310:14 | Run/Start Control: Circuit Short to Ground or Open | For vehicles equipped with a conventional ignition switch, GO to Pinpoint Test C For vehicles equipped with a push button ignition switch, GO to Pinpoint Test F |
| U300A:01 | Ignition Switch: General Electrical Failure | GO to Pinpoint Test K |
| All other Diagnostic Trouble Codes (DTCs) | - | REFER to: Body Control Module (BCM) . |
Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .