LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 161 (Information And Entertainment System - General Information - Vehicles Without: Sync) >> Diagnosis And Testing >> Information and Entertainment System >> DTC Chart: FCDIM

DTC Chart: FCDIM

WARNING: This page is about a different car, the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
DTC Description Action
C1001:01 Vision System Camera: General Electrical Failure REFER to: Parking Aid .
U0140:00 Lost Communication With Body Control Module: No Sub Type Information GO to Pinpoint Test Q 
U0155:00 Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information GO to Pinpoint Test S 
U0159:00 Lost Communication With Parking Assist Control Module "A": No Sub Type Information GO to Pinpoint Test T 
U0184:00 Lost Communication With Radio: No Sub Type Information GO to Pinpoint Test U 
U0256:00 Lost Communication With Front Controls Interface Module "A": No Sub Type Information GO to Pinpoint Test V 
U2013:87 Switch Pack: Missing Message GO to Pinpoint Test V 
U201A:51 Control Module Main Calibration Data: Not Programmed This DTC sets due to incomplete or incorrect PMI procedures. CHECK the vehicle service history for recent service actions related to the FCDIM.
If there have been recent service actions with the FCDIM, INSTALL as-built data from PTS, using the diagnostic scan tool. REFER to: Module Configuration - System Operation and Component Description .
If there have been no recent service actions, INSTALL a new FCDIM to correct the failure to retain configuration data. REFER to: Front Control/Display Interface Module (FCDIM) .
U2100:00 Initial Configuration Not Complete: No Sub Type Information This DTC sets due to incomplete or incorrect PMI procedures. CHECK the vehicle service history for recent service actions related to the FCDIM.
If there have been recent service actions with the FCDIM, INSTALL as-built data from PTS, using the diagnostic scan tool. REFER to: Module Configuration - System Operation and Component Description .
If there have been no recent service actions, INSTALL a new FCDIM to correct the failure to retain configuration data. REFER to: Front Control/Display Interface Module (FCDIM) .
U2101:00 Control Module Configuration Incompatible: No Sub Type Information This DTC sets due to incomplete or incorrect PMI procedures. CHECK the vehicle service history for recent service actions related to the FCDIM.
If there have been recent service actions with the FCDIM, INSTALL as-built data from PTS, using the diagnostic scan tool. REFER to: Module Configuration - System Operation and Component Description .
If there have been no recent service actions, INSTALL a new FCDIM to correct the failure to retain configuration data. REFER to: Front Control/Display Interface Module (FCDIM) .
U3000:41 Control Module: General Checksum Failure CLEAR the DTC.
WAIT at least 10 seconds.
REPEAT the self-test.
If DTC U3000:41 is retrieved again, INSTALL a new FCDIM. REFER to: Front Control/Display Interface Module (FCDIM) .
U3000:42 Control Module: General Memory Failure CLEAR the DTC.
WAIT at least 10 seconds.
REPEAT the self-test.
If DTC U3000:42 is retrieved again, INSTALL a new FCDIM. REFER to: Front Control/Display Interface Module (FCDIM) .
U3003:16 Battery Voltage: Circuit Voltage Below Threshold GO to Pinpoint Test X 
U3003:17 Battery Voltage: Circuit Voltage Above Threshold GO to Pinpoint Test Y 
scientia non olet · About LEMON Manuals