Ignition Coil-On-Plug: Removal

WARNING: Before beginning any service procedure, refer to Safety Warnings in General Information . Failure to follow this instruction may result in serious personal injury.

NOTE: Removal steps in this procedure may contain installation details.

Refer to: Health and Safety Precautions . Refer to: Engine Ignition - Component Location .
If equipped, remove the engine cover.
NOTE: Use compressed air to remove any foreign material from the ignition coil-on-plug and surrounding area before removing the ignition coil-on-plug.

Disconnect the 4 ignition coil-on-plug electrical connectors.
Remove the 4 ignition coil-on-plug bolts.
Torque: 89 lb.in (10 Nm)
NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.

NOTE: When installing apply a small amount of silicone brake caliper grease and dielectric compound to the inside of the ignition coil-on-plug boots before installation.

Remove the 4 ignition coil-on-plugs.

Material: Motorcraft® Silicone Brake Caliper Grease and Dielectric Compound / XG-3-A (ESE-M1C171-A)