Throttle Body: Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the air cleaner outlet pipe. Refer to: Air Cleaner Outlet Pipe .
1. Detach the throttle body wiring harness retainer.
2. Disconnect the throttle body electrical connector.
3. Remove the throttle body retaining bolts.
  Torque: 89 lb.in (10 Nm)
4. Remove the throttle body.
Courtesy of FORD MOTOR COMPANY
NOTE: The gasket is to be reused unless damaged.

Inspect the throttle body gasket, clean and replace the throttle body gasket as needed.

Courtesy of FORD MOTOR COMPANY