Pinpoint Test QC: On Board Diagnostic (OBD) Systems Readiness
Normal Operation and Fault Conditions
Refer to the DTC Fault Trigger Conditions.
The vehicle may not have completed an OBD drive cycle. This is indicated by the inspection maintenance readiness status not complete. In some areas, the OBD drive cycle must be completed to pass the test. Refer to OBD Drive Cycle.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Condition |
|---|---|---|
| PCM P1001:00 | KOER Not Able to Complete, KOER Aborted: No Sub Type Information | This non-MIL DTC sets when the KOER self-test does not complete in the time allowed. |
Possible Sources
- Unexpected response from the self-test monitors
- PCM
Pinpoint Tests QC: On Board Diagnostic (OBD) Systems Readiness