LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling - 2.0L DURATEC-He (110KW/150PS) - Mi4 >> Removal And Installation >> Coolant Pump >> Removal

Coolant Pump: Removal

  1. Drain the cooling system. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding .
  2. Remove the RH headlamp assembly. Refer to: Headlamp Assembly .
  3. Release the degas bottle support tabs and position the degas bottle aside.
    GFD570320Courtesy of FORD MOTOR COMPANY
  4. Remove the engine mount bolts.
    GFD571064Courtesy of FORD MOTOR COMPANY
  5. Using a floor jack and wooden block, support and raise the engine.

    Use the General Equipment: Trolley Jack

    Use the General Equipment: Wooden Block

    GFD571065Courtesy of FORD MOTOR COMPANY
  6. Remove the bolt and the accessory drive belt cover.
    GFD571066Courtesy of FORD MOTOR COMPANY
  7. Loosen the coolant pump pulley bolts. Loosen: 2 turn(s)
    GFD571067Courtesy of FORD MOTOR COMPANY
  8. WARNING: The tensioner is under spring tension. Be careful when handling the tensioner. Failure to follow this instruction may result in personal injury.
    NOTE: Position the accessory drive belt so no coolant will drip on the belt, or the belt may be contaminated.

    1. Using a suitable tool, retract the accessory drive belt tensioner.
    2. Position aside the accessory drive belt.
    3. Release the accessory drive belt tensioner.

    GFD571068Courtesy of FORD MOTOR COMPANY
  9. Remove the bolts and the coolant pump pulley.
    GFD571069Courtesy of FORD MOTOR COMPANY
  10. Remove the bolts and the coolant pump.
    GFD571070Courtesy of FORD MOTOR COMPANY
  11. Discard the O-ring seal.
GFD571071Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals