DTC Chart: Body Control Module (BCM)
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. For information about these practices, REFER to: Diagnostic Methods .
| DTC | Description | Action |
|---|---|---|
| B1315:11 | Backlighting (Non Reflective Controls) Illumination Output: Circuit Short To Ground | GO to Pinpoint Test A |
| B1315:15 | Backlighting (Non Reflective Controls) Illumination Output: Circuit Short To Battery or Open | If all non-networked illumination sources are inoperative, GO to Pinpoint Test A If all non-networked illumination sources are always on, GO to Pinpoint Test B |
| U1000:00 | Solid State Driver Protection Activated - Driver Disabled: No Sub Type Information | The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the BCM can withstand. The cause of the excessive current draw MUST be corrected before a new BCM is installed. ADDRESS all other DTCs first. After the cause of the concern is corrected, For vehicles without active park assist, INSTALL a new BCM. Refer to Body Control Module (BCM) |
| U3000:49 | Control Module: Internal Electronic Failure | REFER to: Body Control Module (BCM) . |
| All other BCM Diagnostic Trouble Codes (DTCs) | - | REFER to: Body Control Module (BCM) . |