Normal Operation and Fault Conditions
With the ignition ON, the PAM sends messages to the ABS module through the GWM over the HS-CAN 1. If the ABS module does not receive these messages within a certain time frame, the module sets DTCs. For information on the messages sent to the ABS module by the PAM, refer to the Network Message Chart in Description and Operation in the Anti-Lock Brake System (ABS) and Stability Control article.
PPT BY ABS MODULE DTC FAULT TRIGGER CONDITIONS
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U0159:00 | Lost Communication With Parking Assist Control Module 'A': No Sub Type Information | This DTC sets when the ABS module does not receive messages from the PAM in the allotted time. This can be due to a PAM failure, a circuit failure on the network or an excessive load on the network. |