LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> Brakes >> Brakes Control Systems >> Abs Guided Routine Testing - Pinpoint Tests A - AZ >> Abs Pinpoint Tests >> Pinpoint Tests AH: Brake Booster Vacuum Supply Faults >> Possible Causes

Possible Causes

  1. AH1: CHECK THE ABS MODULE DTCS 
    • Ignition ON, engine OFF.

    Carry out the ABS self-test.

    • Is DTC C0047:xx, C101A:xx, C1B14:xx, or C1B15:xx also present in the ABS module? 
    Yes No
    If DTC C1B15:xx is present, GO to PINPOINT TEST C .
    If DTC C1B14:xx is present, GO to PINPOINT TEST C .
    If DTC C101A:xx is present, GO to PINPOINT TEST CA .
    If DTC C0047:xx is present, GO to PINPOINT TEST C .
    For all others, No fault found.
    REFER to the ABS Module DTC Chart.    		 Go to  AH2.
  2. AH2: CHECK FOR VACUUM LEAKS 
    • Ignition ON, engine running.
    • Inspect the vacuum hose and each hose connection from the engine to the brake booster for leaks.
    • Are any vacuum leaks found? 
    Yes No
    REPAIR the vacuum leak or INSTALL new components as necessary. Go to  AH4.
  3. AH3: CHECK FOR VACUUM LEAKS 
    • Ignition ON, engine running.
    • Inspect the vacuum hose and each hose connection from the vacuum pump to the brake booster for leaks.
    • Are any vacuum leaks found? 
    Yes No
    REPAIR the vacuum leak or INSTALL new components as necessary. Go to  AH5.
  4. AH4: CHECK THE VACUUM SUPPLY TO THE BRAKE BOOSTER 
    • Ignition OFF.
    • Disconnect the vacuum hose from the brake booster.
    • Connect a vacuum gauge to the vacuum hose.
    • Ignition ON, engine running.
    • Monitor the vacuum gauge.
    • Does the vacuum gauge display a steady reading greater than 600 mBar (18 In-Hg)? 
    Yes No
    INSTALL a new brake booster. REFER to the Power Brake Actuation article. DIAGNOSE the engine vacuum concern. CARRY OUT the Intake Manifold Vacuum Test. REFER to the Engine System General Information, Diagnosis and Testing article.
  5. AH5: CHECK THE VACUUM PUMP OUTPUT 
    • Ignition OFF.
    • Disconnect the vacuum hose from the brake booster.
    • Connect a vacuum gauge to the vacuum hose.
    • Ignition ON, engine running.
    • Monitor the vacuum gauge.
    • Does the vacuum gauge display greater than 600 mBar (18 In-Hg)? 
    Yes No
    INSTALL a new brake booster. REFER to the Power Brake Actuation article. INSTALL a new vacuum pump. REFER to the appropriate procedure in the Power Brake Actuation article.
scientia non olet · About LEMON Manuals