Pinpoint Test X: P06B8:00, U0300:00, U0422:00, U201A:89, U2100:00, U2200:00 Or U3000:49

Normal Operation and Fault Conditions

REFER to: Handles, Locks, Latches and Entry Systems - Vehicles With: One-Touch Open and Close Front Windows - System Operation and Component Description .

DTC Fault Trigger Conditions

DTC	Description	Fault Trigger Condition
DDM P06B8:00	Internal Control Module Non-Volatile Random Access Memory (NVRAM) Error: No Sub Type Information	Sets when the DDM detects an internal software issue.
DDM U0300:00	Internal Control Module Software Incompatibility: No Sub Type Information	Sets when the DDM detects an internal software issue.
DDM U0422:00	Invalid Data Received From Body Control Module: No Sub Type Information	Sets when the DDM detects an internal software issue.
DDM U2100:00	Initial Configuration Not Complete: No Sub Type Information	Sets when the DDM detects an internal software issue.
DDM U2200:00	Control Module Configuration Memory Corrupt: No Sub Type Information	Sets when the DDM detects an internal software issue.
DDM U3000:49	Control Module: Internal Electronic Failure	Sets when the DDM detects an internal software issue.
PDM P06B8:00	Internal Control Module Non-Volatile Random Access Memory (NVRAM) Error: No Sub Type Information	Sets when the PDM detects an internal software issue.
PDM U0300:00	Internal Control Module Software Incompatibility: No Sub Type Information	Sets when the PDM detects an internal software issue.
PDM U0422:00	Invalid Data Received From Body Control Module: No Sub Type Information	Sets when the PDM detects an internal software issue.
PDM U2100:00	Initial Configuration Not Complete: No Sub Type Information	Sets when the PDM detects an internal software issue.
PDM U2200:00	Control Module Configuration Memory Corrupt: No Sub Type Information	Sets when the PDM detects an internal software issue.
PDM U3000:49	Control Module: Internal Electronic Failure	Sets when the PDM detects an internal software issue.

Possible Sources

DDM
PDM

X1 CHECK FOR DIAGNOSTIC TROUBLE CODES (DTCS)

Using a diagnostic scan tool, clear all Diagnostic Trouble Codes (DTCs).

Using a diagnostic scan tool, perform the DDM or PDM self-test.

Did the DTC return?

Yes	INSTALL a new DDM or PDM. REFER to: Front Door Module (FDM) .

No	The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.