LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wipers And Washers >> Diagnosis And Testing >> Wipers and Washers >> Pinpoint Tests >> Pinpoint Test I: The Windshield Washer Is Always On >> Pinpoint Test I: The Windshield Washer Is Always On

Pinpoint Test I: The Windshield Washer Is Always On

  1. I1 CHECK THE WIPER/WASHER SWITCH INPUT USING THE WASHER SWITCH (FRONT) (F_WASH_SW) PID

    • Ignition ON.

    • Using a diagnostic scan tool, view the SCCM PID.

    • Using a diagnostic scan tool, view the SCCM wiper/washer switch PID F_WASH_SW:

    Does the PID indicate the switch is activated? 

    Yes  INSTALL a new wiper/washer switch. REFER to: Steering Column Multifunction Switch LH . TEST the system for normal operation. If the concern is still present, GO to  I2
    No  INSTALL a new windshield wiper motor. REFER to: Windshield Wiper Motor .

  2. I2 CHECK FOR CORRECT SCCM (STEERING COLUMN CONTROL MODULE) OPERATION

    • Disconnect and inspect all the SCCM connectors.

    • Repair:

      • corrosion (install new connector or terminal - clean module pins)
      • damaged or bent pins - install new terminals/pins
      • pushed-out pins - install new pins as necessary

    • Reconnect the SCCM connectors. Make sure it seats and latches correctly.

    • Operate the system and determine if the concern is still present.

    Is the concern still present? 

    Yes  CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new SCCM.
    No  The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues.
scientia non olet · About LEMON Manuals