LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Parking Aid - Vehicles With: Parking Aid Camera >> Diagnosis And Testing >> Parking Aid >> Pinpoint Test(s) >> Pinpoint Test C: The Visual Park Aid Alert Is Inoperative

Pinpoint Test C: The Visual Park Aid Alert Is Inoperative

  1. Normal Operation and Fault Conditions 

    See Visual Park Aid Alert. REFER to: Parking Aid - System Operation and Component Description .

    Possible Sources 

    • Rear parking aid camera
    • PAM concern
    • BCM concern

    Visual Inspection and Pre-checks 

    • If the rear parking aid camera is not configured after replacement, some video functions will be inoperative. Turn the ignition on for 5 minutes to allow the camera/BCM calibration to complete.
    • For vehicles equipped with a touchscreen centerstack infotainment display, verify that the parking aid alert is enabled in FDIM settings menu.

  2. C1 PERFORM A NETWORK TEST

    • Ignition ON.

    • Using a diagnostic scan tool, perform a network test.

    Do all modules pass the network test? 

    Yes  GO to  C2
    No  REFER to: Communications Network .

  3. C2 CHECK THE PAM (PARKING ASSIST CONTROL MODULE) CONTINUOUS MEMORY DIAGNOSTIC TROUBLE CODES (CMDTCS)

    • Using a diagnostic scan tool, check the PAM Continuous Memory Diagnostic Trouble Codes (CMDTCs).

    Are any Continuous Memory Diagnostic Trouble Codes (CMDTCs) present? 

    Yes  REFER to: Parking Aid .
    No  GO to  C3

  4. C3 CHECK THE BCM (BODY CONTROL MODULE) CONTINUOUS MEMORY DIAGNOSTIC TROUBLE CODES (CMDTCS)

    • Using a diagnostic scan tool, check the BCM Continuous Memory Diagnostic Trouble Codes (CMDTCs).

    Continuous Memory Diagnostic Trouble Codes (CMDTCs) present? 

    Yes  REFER to BCM DTC Chart 
    No  GO to  C4

  5. C4 CHECK FOR CORRECT VIDEO CAMERA OPERATION

    • Ignition ON.

    • Disconnect and inspect the rear parking aid camera connector and related in-line connectors.

    • Repair:

      • corrosion (install new connector or terminals - clean module pins)
      • damaged or bent pins - install new terminals/pins
      • pushed-out pins - install new pins as necessary

    • Reconnect the rear parking aid camera connector. Make sure it seats and latches correctly.

    • Operate the system and determine if the concern is still present.

    Is the concern still present? 

    Yes  CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new camera. REFER to: Rear Parking Aid Camera .
    No  The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues.
scientia non olet · About LEMON Manuals