Vehicles Equipped With A Non Touchscreen Display

NOTE: The liftgate or cargo doors must remain closed for correct operation of the camera system.

The parking aid camera image is displayed by the FCDIM when the transmission is placed in reverse. To determine the selector lever position and enable the rear parking aid camera display, the FCDIM receives the transmission gear in reverse message from the PCM through the Infotainment Controller Area Network (I-CAN), with the IPC and BCM serving as gateways. The camera generates a video signal any time it receives voltage, regardless of the current configuration. If the parking aid camera is not configured properly, some features may be inoperative. The camera is supplied voltage by the BCM when the ignition is on. When the camera is on, the image signal is sent from the parking aid camera on shielded twisted pair wires to the FCDIM.

Vehicles equipped with the non touchscreen display do not have any features that can be configured by the driver. The system displays fixed guidelines that cannot be turned off. If the vehicle is equipped with front and rear parking aid, the system has the video delay feature that cannot be turned off.