LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Bumpers >> Removal And Installation >> Front Bumper Cover >> Removal

Front Bumper Cover: Removal

NOTE: Removal steps in this procedure may contain installation details.
  1. Remove the headlamp assembly. Refer to: Headlamp Assembly .
  2. Disconnect the hood safety latch cable and position aside.
    GFD574374Courtesy of FORD MOTOR COMPANY
  3. Remove the screws.
    GFD574375Courtesy of FORD MOTOR COMPANY
  4. On both sides. Remove the push pins and position the fender liner aside.
    GFD574376Courtesy of FORD MOTOR COMPANY
  5. Remove the radiator deflector screws.

    Use the General Equipment: Interior Trim Remover

    GFD574377Courtesy of FORD MOTOR COMPANY
  6. Release the tabs and separate the outer edges of the front bumper cover assembly.
    GFD574378Courtesy of FORD MOTOR COMPANY
  7. Remove the front bumper cover.

    1. Release the tabs.
    2. If equipped. Disconnect the electrical connectors.

GFD574379Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals