LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Handles, Locks, Latches And Entry Systems (2 Of 2) >> Diagnosis And Testing >> Locks, Latches and Entry Systems - Vehicles With: One-Touch Open and Close Front Windows >> Pinpoint Tests >> Pinpoint Test Ad: U0232:00, U0233:00

Pinpoint Test Ad: U0232:00, U0233:00

  1. Normal Operation and Fault Conditions 

    The DDM communicates with the SODL over the CAN. If the DDM does not receive messages from the SODL, the side obstacle detection feature can be inoperative for the left side.

    The PDM communicates with the SODR over the CAN. If the PDM does not receive messages from the SODR, the side obstacle detection feature can be inoperative for the right side.

    DTC Fault Trigger Conditions 

    DTC Description Fault Trigger Condition
    DDM U0232:00 Lost Communication With Side Obstacle Detection Control Module "A": No Sub Type Information Sets when the DDM detects data messages are missing from the SODL.
    DDM U0233:00 Lost Communication With Side Obstacle Detection Control Module "B": No Sub Type Information Sets when the DDM detects data messages are missing from the SODR.
    PDM U0232:00 Lost Communication With Side Obstacle Detection Control Module "A": No Sub Type Information Sets when the PDM detects data messages are missing from the SODL.
    PDM U0233:00 Lost Communication With Side Obstacle Detection Control Module "B": No Sub Type Information Sets when the PDM detects data messages are missing from the SODR.

    Possible Sources 

    • Network communication concern
    • PDM
    • DDM
    • SODR
    • SODL

  2. AD1 VERIFY THE CUSTOMER CONCERN

    • Ignition ON.

    • Verify there is an observable symptom present.

    Is an observable symptom present? 

    Yes  GO to  AD2
    No  The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

  3. AD2 CHECK THE COMMUNICATION NETWORK

    • Using a diagnostic scan tool, carry out the network test.

    Does the SODL and the SODR pass the network test? 

    Yes  GO to  AD3
    No  REFER to: Communications Network .

  4. AD3 CHECK FOR SODL (SIDE OBSTACLE DETECTION CONTROL MODULE LH) / SODR (SIDE OBSTACLE DETECTION CONTROL MODULE RH) DIAGNOSTIC TROUBLE CODES (DTCS)

    • Using a diagnostic scan tool, carry out the SODL/ SODR self-test.

    Are any voltage related Diagnostic Trouble Codes (DTCs) present? 

    Yes  REFER to: Blind Spot Information System .
    No  GO to  AD4

  5. AD4 RECHECK THE DDM (DRIVER DOOR MODULE) / PDM (PASSENGER DOOR MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)

    NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during PMI or the PMI may not have been carried out.

    • Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs) and repeat the DDM/ PDM self-test.

    Is DTC U0232:00/U0233:00 still present? 

    Yes  GO to  AD5
    No  The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

  6. AD5 CHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) U0232/U0233 SET IN OTHER MODULES

    • Using a diagnostic scan tool, clear all Diagnostic Trouble Codes (DTCs).

    • Ignition OFF.

    • Ignition ON.

    • Wait 30 seconds.

    • Using a diagnostic scan tool, retrieve the Continuous Memory Diagnostic Trouble Codes (CMDTCs) from all modules.

    Is DTC U0232/U0233 set in other modules? 

    Yes  INSTALL a new SODL/ SODR. REFER to: Side Obstacle Detection Control Module .
    No  INSTALL a new DDM/ PDM. REFER to: Front Door Module (FDM) .
scientia non olet · About LEMON Manuals