LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Mustang Mach-E Select, RWD >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation, Message Center And Warning Chimes >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test Bl: The Ready To Drive Chime Is Inoperative

Pinpoint Test Bl: The Ready To Drive Chime Is Inoperative

  1. Normal Operation and Fault Conditions 

    See Ready to Drive Chime. REFER to: Warning Chimes - System Operation and Component Description .

    Possible Sources 

    • Communication concern
    • SOBDMC
    • GWM
    • IPC

  2. BL1 CHECK THE SEATBELT WARNING CHIME OPERATION

    • Ignition OFF.

    • Ignition ON.

    • Monitor the seatbelt warning chime when the ignition switch is transitioned from OFF to RUN for 6 seconds.

    Does the seatbelt warning chime operate for approximately 6 seconds? 

    Yes  GO to  BL2
    No  GO to Pinpoint Test A 

  3. BL2 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST

    • Using a diagnostic scan tool, perform the IPC self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to Diagnostic Trouble Code (DTC) Chart .
    No  GO to  BL3

  4. BL3 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)

    • Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (DTCs).

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to: Controller Area Network (CAN) Module Communications Network .
    No  DIAGNOSE all SOBDMC Diagnostic Trouble Codes (DTCs). REFER to the appropriate DTC Chart.
scientia non olet · About LEMON Manuals