LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Mustang Mach-E Select, RWD >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation, Message Center And Warning Chimes >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test BS: U3000:04 Or U3000:46

Pinpoint Test BS: U3000:04 Or U3000:46

  1. DTC Fault Trigger Conditions 
    DTC Description Fault Trigger Condition
    IPC U3000:04 Control Module: System Internal Failures Sets in the IPC when the IPC detects an EEPROM failure.
    IPC U3000:46 Control Module: Calibration/Parameter Memory Failure Sets in the IPC when the IPC detects an EEPROM failure.

    Possible Sources 

    • IPC

  2. BS1 RETRIEVE IPC (INSTRUMENT PANEL CLUSTER) DIAGNOSTIC TROUBLE CODES (DTCS)

    • Ignition ON.

    • Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs).

    • Wait 10 seconds.

    • Using a diagnostic scan tool, perform the IPC self-test.

    Is U3000:04 or U3000:46 recorded? 

    Yes  INSTALL a new IPC. REFER to: Instrument Panel Cluster (IPC) .
    No  The system is operating correctly at this time.
scientia non olet · About LEMON Manuals